Lupine SL S not working properly
Verfasst: 24.07.2019, 14:59
Hello,
Appologies for using English. I have a giant Quick e+ 2018. I added a lupine SL S to this bike in October 2018. The light was working fine during the winter season when it was very dark. Recently I was trying to ride the bike at night but the light shuts off after 16 seconds. I can toggle the light switch on the Giant/Yamaha control panel to turn off the light and turn it back on again. The light will then stay on for 16 seconds and then turn off.
The day time lights seem to work properly and do not turn off. I have tried various combinations of pressing the button under neath the light but that hasn't fixed anything. According to https://www.lupine-shop.com/media/pdf/0 ... al_web.pdf I I should be able to reset to factory setings by pressing the button 4 times but that doesn't seem to work. I don't understand the documentation very well. It says 'Keep the button pressed (let go to select) to SL". Does that mean I should press it three times and long press on the fourth time?? I do not understand.
The one thing that is unique on my setup is that I had to wire the light into the existing wire harness by cutting and splicing the wire. This was working fine and I don't understand why the wiring would cause the light to turn off after 16 seconds.
Appologies for using English. I have a giant Quick e+ 2018. I added a lupine SL S to this bike in October 2018. The light was working fine during the winter season when it was very dark. Recently I was trying to ride the bike at night but the light shuts off after 16 seconds. I can toggle the light switch on the Giant/Yamaha control panel to turn off the light and turn it back on again. The light will then stay on for 16 seconds and then turn off.
The day time lights seem to work properly and do not turn off. I have tried various combinations of pressing the button under neath the light but that hasn't fixed anything. According to https://www.lupine-shop.com/media/pdf/0 ... al_web.pdf I I should be able to reset to factory setings by pressing the button 4 times but that doesn't seem to work. I don't understand the documentation very well. It says 'Keep the button pressed (let go to select) to SL". Does that mean I should press it three times and long press on the fourth time?? I do not understand.
The one thing that is unique on my setup is that I had to wire the light into the existing wire harness by cutting and splicing the wire. This was working fine and I don't understand why the wiring would cause the light to turn off after 16 seconds.