Lupine Forum

I have just got my new Piko X a few weeks ago. It worked fine for the first couple of days, but then it refused to switch on.

I send it in for repair, and got it back with the same dissapointing result.

Now I had it in my car over night so that I could ship it this morning. By pure accident I tryed to switch it on just one more time, and it worked.
After having used it during my run this afternoon, I once again can not switch it on.

What can possibly be wrong and should I return it for repair one more time.

Hello!
This is a strange problem. Have you even checked the plug and put the plug together you always right? Makes the lamp an initialization if you flash it with the battery connections, = the blue and red LEDs of the battery voltage.
If all is ok then the pico again to lupine.

I believe to have checked all the connections thoroughly.
The blue/red light does not come on when connecting.
The red light is seen vagely perhaps for a split second when I try to switch the lamp on.

Have a PIKO. I just tested it again. The Piko briefly lights up with red LED and blue LED. She then makes it accessible initialization of the battery voltage. The full-voltage blue LED and the tenth of a volt then the red LED.

If that's you not, then the lamp to lupine. This is always very fast and you're back.